12
50mm x 50mm x 1.6mm Steel Post For Wall Mounting
50mm x 50mm x 1.6mm Steel Post For Wall Mounting

50mm x 50mm x 1.6mm Steel Post For Wall Mounting

CODE: 50 - 1090 Wall Post
$46.50 Inc. GST
$0.00
$46.50
50mm x 50mm x 1.6mm Steel Post For Wall Mounting

50mm x 50mm x 1.6mm Steel Post For Wall Mounting

$0.00 $46.50
50mm x 50mm x 1.6mm Steel Post For Wall Mounting
50mm x 50mm x 1.6mm Steel Post For Wall Mounting

50mm x 50mm x 1.6mm Steel Post For Wall Mounting

$0.00 $46.50
Length: 1090mm
Description
Description
x

Australian Made Steel Posts

Where the Run Meets the Wall,
the Detail Shows.

Your panels get the compliments. Your posts decide whether the line still runs true in twenty years. This is a 50 × 50 × 1.6mm galvanised Australian steel post, supplied with its colour-matched cap and masonry fixings — ready to carry fencing, balustrades, privacy screens and gates, and hold every one of them exactly where you set it.

Structure

Straight Lines Start Here

Wall-mounted posts do the quiet work of tying a run into the built structure. Ours are cut from 50 × 50 × 1.6mm galvanised Australian steel, pre-drilled on site to suit your wall, and fixed hard against brick, block or render so the panel sits square and the line carries through without a kink.

Complete Kit

Nothing Left to Chase Up

Every post arrives with a colour-matched snap-on post cap and two Mungo bolts included — the right masonry fixing for brick, block and render, supplied with the post rather than guessed at on site. The detail that finishes the job is already in the box.

Longevity

Galvanised First, Then Finished

Posts sit where water sits — at ground level, against concrete, in the weather. Ours start as galvanised steel, then receive our Four-Stage Bonded Powder Coat in your choice of 26 premium colours. Protection underneath, colour on top, and a finish that holds its lustre through Australian summers and coastal air alike.

Engineering Specifications

50 × 50 × 1.6mm Post for Wall Mounting

Post section 50 × 50 × 1.6mm SHS
Material Galvanised Australian steel
Application Wall, pier and house mounting to close or start a run
Available lengths 1090mm, 1350mm, 1650mm, 1800mm, 2100mm
Included Colour-coded snap-on post cap + 2 × Mungo bolts
Finish Four-Stage Bonded Powder Coat, 26 premium colours
Origin Designed, fabricated and finished in Tamworth, NSW

Choosing Your Post

Match the Post to the Panel

Post size is a structural decision, not a style one. Taller and wider panels carry more wind load, and gates carry more again — so both the section and the length change with the job. Here is how our post lengths line up with our standard panel heights.

Post length Suits panel height Post above panel Clearance below panel
1090mm 940mm 70mm 80mm
1350mm 1200mm 70mm 80mm
1650mm 1500mm 70mm 80mm

1800mm and 2100mm lengths are also stocked for gate posts, sloping sites and custom panel heights.

Mason & Dean post length guide for wall mounting showing 1090mm, 1350mm and 1650mm posts fixed against a wall to suit 940mm, 1200mm and 1500mm high panels
  • Finishing against a wall, pier or house? This wall-mount post closes the run neatly.
  • Working to a slab, deck, path or existing footing? Our bolt-down base plate post is the straightforward choice.
  • Setting into soil or new concrete? Our matching post for concreting anchors below ground.
  • Not certain? Send us your run length, panel heights and site photos and our product specialists will spec it with you.

Installation

A Clean Finish Against Brick, Block or Render

Pre-drill your fixing holes in the post, then hold it against the wall in position and level it. Mark your drilling points, drill into the wall, insert your anchors and secure the post with the Mungo bolts supplied. Finish by snapping the colour-matched cap into place.

That's it. And if anything about your site is unusual — a slope, a tight boundary, an awkward corner — call us before you start. We'd rather spend ten minutes on the phone than have you buy twice.

Why Mason & Dean

The People Who Answer the Phone
Are the People Who Designed It

Mason & Dean is founder-led. The people who answer the phone are the ones who started the business and drew every profile in the range, so the advice you get is first-hand rather than read off a screen. Every post is made in our Tamworth workshop, colour-matched to the fence panels, gates and balustrades it supports, and backed by our 10-Year Warranty.

Posts rarely get chosen on their own. If you're still finalising the run, browse the matching fence panels, balustrades, privacy screens and gates that these posts are built to carry — all finished in the same 26 premium colours.

Need a hand sizing your posts? Call our product specialists on (02) 6762 5249 or send us your plans.

Related Products

Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50
Example product title
From $46.50 Inc. GST
$0.00
From $46.50

Recently Viewed Products